Universal band saw made of wood 2 part, original clock made of wood and epoxy resin.

Materials Needed:

Hardwood lumber for the frame and components (such as maple, oak, or beech)
Plywood for the tabletop and motor mount
Metal rod or pipe for the bandsaw blade guides
Metal or plastic wheels for the blade tensioner and tracking
Bearings for the wheels and blade guides
Bandsaw blade
Hardware (screws, nuts, bolts, washers)
Wood glue
Epoxy resin (for stabilizing and reinforcing certain components, optional)
Sandpaper
Finish (such as oil or varnish)
Tools Needed:

Table saw or circular saw
Bandsaw (for cutting curved components)
Drill press or hand drill
Router and router bits (for shaping and profiling)
Chisels and hand planes
Clamps
Measuring tools (tape measure, square, marking gauge)
Step-by-Step Guide:

Design Planning:

Start by designing the universal band saw, considering factors such as the size of the cutting capacity, the frame structure, and the placement of key components such as the motor, wheels, and blade guides.
Prepare the Lumber:

Mill your hardwood lumber to the appropriate dimensions for the frame, tabletop, and other components. Ensure that all pieces are flat, straight, and free from defects.
Cut and Shape Components:

Cut the components for the frame, tabletop, motor mount, and other parts according to your design. Use a combination of power tools (such as a table saw) and hand tools (such as chisels and hand planes) to achieve the desired shapes and profiles.
Assemble the Frame:

Assemble the frame of the band saw, including the main uprights, horizontal supports, and base. Use wood glue and screws to join the components securely, ensuring that the frame is sturdy and square.
Install the Wheels:

Install the wheels for the blade tensioner and tracking mechanism. These wheels will guide the bandsaw blade and allow for adjustments to maintain proper tension and alignment.
Add the Blade Guides:

Attach the blade guides to the frame using metal rods or pipes and bearings. These guides will help support and stabilize the bandsaw blade during operation, reducing vibration and ensuring accurate cuts.
Mount the Motor:

Mount the motor to the frame using a motor mount or bracket. Ensure that the motor is aligned properly with the bandsaw wheels and that the drive belt or pulley system is correctly configured.
Install the Tabletop:

Attach the plywood tabletop to the frame, ensuring that it is level and securely fastened. This tabletop will provide a stable surface for supporting workpieces during cutting.
Test and Adjust:

Once the band saw is fully assembled, test its functionality by installing a bandsaw blade and powering it on. Check for proper blade tracking, tension, and alignment, and make any necessary adjustments to ensure smooth and accurate operation.
Finish and Fine-Tuning:

Sand the entire band saw to smooth out any rough edges or surfaces. Apply a finish of your choice to protect the wood and enhance its appearance. Perform any final fine-tuning or adjustments to ensure that the band saw is ready for use.
By following these steps and paying careful attention to detail, you can create a handmade universal band saw made of wood that will serve as a versatile and valuable addition to your woodworking shop.