How to change Crankshaft Position Sensor '98 Jeep Cherokee #subscribe
5 months ago
11
This jeep would just randomly stop running. I could let it sit for about an hour and it would start and drive for about 10-15 minutes and die again. Rinse and repeat. There was no check engine light, fuel pressure was good. Seemed to be no reason for this issue. Did some research and discovered that when this sensor goes out, the check engine light doesn't come on. So changed it out and have not had any problems since! #subscribe #jamesofalltrades #diy #follow #fypã‚· #jeep #jeepcherokee #crankshaft
Loading comments...
-
12:34
LuderCoArms
7 months ago1998 Jeep Cherokee XJ -- Replacing the CPS -- Crankshaft Position Sensor
2 -
8:09
Cliff's Garage
2 years agoHow to Replace a Crankshaft Position Sensor, 2013 Kia Rio (P0335, P0336). Very detailed directions.
4 -
9:58
patriot89
5 months ago98 Jeep Cherokee cam position sensor replacement
7 -
32:07
Low-Buck Garage
1 year agoAdd-on Turn Signal Installed In My CJ-2A Willys Jeep
21 -
10:28
737mechanic
1 year ago2004 Jeep Grand Cherokee Fuel Filter / Regulator Change Due to Long Engine Crank Time.
1 -
0:35
Bigmike7373
3 years ago99 jeep cherokee color change
88 -
1:34
Davidtheexplorer
3 years agoThe idle air control valve on 96 jeep cherokee laredo
67 -
1:12
J20jeepster
1 year agoP0502 CODE No Speedometer and Doesn't up Shift SOLVED
8 -
8:09
Endless Money Pits
3 years agoCrankshaft Position Sensor Replacement 5.2L V8
4 -
11:07
taboocustoms
9 months ago $0.01 earnedJeep TJ Neutral Safety Switch Connector Replacement
24