How to Remove a Wheel Bearing Using Pit Posse PP1692 Wheel Bearing Remover (Street)

More remover sizes available at www.pitposse.com

Driving wheel bearings out without damaging an expensive wheel can be quite a hair pulling task. Fortunately, this set makes the job almost effortless. It works on virtually any size wheel bearing on both motorcycles and atv’s. Safe and easy. Will fit most bikes and atv’s

The set consist of 7 removers 25mm, 20mm, 19mm, 17mm, 15mm, 12mm and 10mm & 2 rods to fit all bearing sizes with storage case. Each remover has a tapered end so part of the remover will slip inside the bearing. How it works: simply put the proper size remover in the bearing, then flip wheel & bearing over so the remover is against the floor, take the rod tool insert into remover and tap firmly into place (the remover has a slot in it for the rod tool to slide into ) once you have the rod firmly in place simply lift the wheel and bearing off the ground and tap again until the bearing falls out. When the remover is against the ground and taped on, the remover is spread apart tight against the bearing, then when you lift off the ground and tap, it pushes the bearing out of the race. You will be able to remove bearings in seconds with this tool.
Get yours today: https://www.pitposse.com/pit-posse-9-piece-bearing-remover-set.html

Check out our Made in USA line of trailer accessories at www.pitposse.com