Tube Magazine Repair - turning brass and tig welding
5 months ago
206
This could have been a LOT worse. There was a jam where more than one cartridge slipped into the carrier. When the lever was pulled out, one round went off below the bolt. This set off a chain reaction where 2 other cartridges went off sending a third now compressed cartridge down the tube destroying the follower and the spring then tearing the magazine cap out of the magazine tube. I hammered the torn metal back into place the best I could then welded it back together. It came out very good. Not perfect, but very good.
Loading comments...
-
36:01
Gunsmith
1 year ago $0.03 earnedAnother Fire Damaged AR - Test Firing - Part 4
1161 -
3:54
FormerGorilla
1 year ago $0.04 earnedReloading - Removing Bullet from Brass
119 -
0:33
Doggorunning
1 year agoRusted bolts in your rifle? Easy fix that won’t ruin bluing #gun
26 -
9:55
Kit Badger Videos
1 year ago $0.01 earnedCZ 527 Carbine: Barrel Threading by IAT
3581 -
9:40
FirearmsGuide.com - Guns & Ammo Reference Guide + Gun Values + Gunsmithing Library
2 months ago25,655 Gunsmith Repair Manuals, Schematics & Gun Blueprints at www.FirearmsGuide.com
287 -
0:29
ApexCustomRifles
1 year agoWell Machined Barrel Threads!
4 -
0:29
pamaxtactical
6 months ago14.5 BILLET AR15 PIN & WELD RIFLE
6 -
27:41
Ultimate Reloader on Rumble
8 months ago $1.09 earned7PRCW Build Part 1: Woox Titano Chassis and Barrel Chambering
5.39K3 -
2:21
bubbafreeney
1 year agoMag guts +2 baseplate modification to fit TD mag flare
35 -
2:15:39
The Guns N Glory Show
1 year ago $0.03 earned30 Caliber Bullets from 5/16" Soft Copper Tubing Using BT SNIPER Dies
47