Sharpening a Card Scraper with a Bias
6 months ago
26
Sharpening a card scraper with a 90 degree edge and four sides with a burr - two top, two bottom, seems to vex hobby woodworkers to the point that many don't roll a burr.
One of the reasons is the wear profile from the prior burr and the cramming of everything into a 90 degree spectrum. Not hard to master, but false economy for most to get four edges instead of two when the four are no good or not very good.
You can improve your results by biasing the angles, filing them at an angle and then honing the tip with a slightly lower angle and then rolling the burr to that honed edge. The bias makes everything easier so you're not trying to hone a filed edge and taking a long time doing stuff that isn't woodworking.
Loading 1 comment...
-
14:05
America Uncovered
16 hours agoCan Trump Get Away With Murder Now?
8783 -
8:48
Adam Does Movies
1 day ago $0.07 earnedThe Acolyte Episode 6 - Skinny-Dip With The Sith - Spoilers!
4942 -
10:01
ParisDemers
1 day agoMiguel O'Hara Workout Plan - Get Jacked Like Spider-Man 2099 (No Spoilers)
1911 -
15:22
CarlCrusher
1 day agoAncient Abandoned Hidden Dwellings Discovered at Skinwalker's Evil Twin
390 -
9:38
JoBlo Originals
20 hours agoDeadpool was just a good X-Men Movie...
7442 -
8:17
LenaPetrova
1 day ago🚨DESTRUCTION OF U.S. MIDDLE CLASS: Home Affordability in the US Sinks to Lowest Point Since 2007
1.59K16 -
33:10
Degenerate Plays
1 day ago $0.04 earnedThe Censorship Problem - Stellar Blade : Part 5
145 -
15:17
Scammer Payback
2 days agoScammer's Reaction after being Hacked
7.25K35 -
2:34:47
GoodLawgic
8 hours agoThe Following Program: Legal Eagle CRY-SPLAINS Immunity; Best Trump Story You NEVER HEARD
33.1K16 -
2:03
Nerdrotic
13 hours agoA Special Announcement - Nerdrotic Returns to Rumble
24K92