How to replace brake pads on a bicycle. Adjusting mechanical disc brakes.

Hello everyone, in this video we're going to take a look at how to replace pads on a bike.
and adjust Shimano BR-M375, BR-TX805 mechanical disc brakes.
Subscribe to the channel, put likes. And we continue.
This video is about mechanical brake caliper of Shimano brand model BR-M375.
Similar model Shimano BR-TX805. The caliper works on a mechanical cable.
Classic disc brake pads. As usual, the brakes are very dirty.
Before replacing the pads, it is essential to clean everything around them, the disk, the frame and the caliper itself. Must be treated with isopropyl alcohol with wet and dry cloths.
Must be perfectly clean. If not, you won't get results!
For everything to work, be sure to repeat after us.
This video will show you all the details. Just repeat after us and the bike will slow down very well.
We are going to change the cable to make the brake work better. The cable was beat up and needed to be replaced, so we just took a bite out of it and installed a new one.
As you can see the pads are worn out, there is very little material left. There are no decks.
We zangina the hairpin that holds the pads. Removal of the pads from the caliper The block was equal to the spring. This is a timely replacement.
If you continue to brake with such pads, then the spring will begin to wear and ruin your disk. New pads must be compatible with your caliper. Make sure they are the same!
Insert the new pads into a clean caliper. Be sure to put the pin back in to keep the pads from falling out. This is for your safety! Remember the dirty knot at the beginning of the video?
Now everything is clean, as it should be! We use isopropyl alcohol to degrease the rotor. It should not be greasy!
After degreasing, we use a gas burner to re-grease the disk. Install the brake caliper on the frame.
Now you will learn that the adjustment of the rear brakes is on the one hand just tedious work on the other hand.
You will see how a mechanic performs adjustments in workshop conditions.
Support the channel of our workshop. Put like write your questions in the comments.
Also, please indicate in the comments. What do you want us to shoot a video.
Shimano BR-m375 brake clit adjustment. Will have to tinker. We have a series of bolts and we need to adjust so that the pads do not hit the rotor.
Two bolts that adjust the fit of the caliper to the frame. One bolt is for the cable tension.
And the last bolt is responsible for the approach of the right pad to the rotor.
This is the end of our video tutorial. Thanks for watching. Rate the video with a Like.
Good luck to all cyclists!
No words, just mechanical sounds in this video. Language-neutral content, internationally accessible. Presented in a do-it-yourself video format.
If you're a biking enthusiast, you'll love this video.Show more

#bikepads #bikemaster #mtb

00:00 How to adjust mechanical disc brakes.
00:41 Beginning to remove the shimano br-m375 caliper.
01:42 Brake system cleaner.
02:07 Replacing shimano brake cable.
03:39 Replacing the pads on a shimano br-tx805 mechanical disc brake.
05:20 Disk brake cleaner.
05:52 Adjusting mechanical disc brakes shimano br-m375, br-tx805.