Solid State Bedini Free Energy

Here I show you a very simple solid state method to experiment with the back EMF radiant voltage spike John Bedini so much spoke of. We can reproduce the same effects, Using a big air core single coil. And pulsing this with low voltage zero current or near zero current.

The idea is to trigger the the high voltage back EMF voltage while holding back and gating the current by keeping the spike sharp so we try to use just pure voltage to save on energy usage or needing very little input drive to produce this backEMF. Now we take this high voltage zero current radiant sharp spike. And send it to two charging batteries hooked up in parallel.

Here I show you how I use a simple tablet with software waveform generator to control the switching ( PWM ) pulse width modulation With the help of the analog sound card port output and a control NPN switching transistor. This sound output from tablet via waveform generator set to fast frequency of 2 khz and tight duty cycle of 6 percent. controls and triggers the base of the transistor to rapidly switch an input 9 volt battery. This is sent to a coil and we collect the back EMF 30 plus high voltage radiant spike. The input battery does not "feel" it much as we are limiting much of the current from leaving the input source.

It's John Bedini's get two for the price of one trick without needing the wheel part. I don't have a machine shop at the moment and wanted to experiment with the Bedini process regardless and found out this method works as good.

Forum:
http://typeright.social/forum

Please Help Support My Research: https://youtu.be/pYXETBB40j0