Self Oscillating LC Circuit Using Kapagen For 20 minutes

1 year ago
70

Great day people, I chose to explore different avenues regarding Electret impacts, They state that Electrets can gather charge, utilizing surrounding energies also. So I followed some simple online guide on the most proficient method to make these and I chose to attempt to explore different avenues regarding operation in low voltage settings as well and to attempt to utilize the Kapagen Coil as such a blender for the High and Low frequencies with a stage focus of 180 degrees. sort of like Tesla attempted to do.

So I am presently utilizing my High Frequency generator in low Voltage mode killing the Spark Gap in this circuit for the time being. The high Frequency goes in the Coil, Grounds are as yet isolated earth Grounds of 20 meters away and the best for the present as in my unique examinations as that is all I have in Grounds until the day off ice and snow melts and afterwards. I could arrange some better Grounds outside.

So for the present I am trusting that with the close by low Frequencies RF encompassing and so on. The blending can occur with my Oscillator driving it, Some have suggested this strategy from the beginning as opposed to relying upon the unadulterated Ambient as in one of my past circuits for the exciter source, But maybe have my own exciter source all things being equal. Furthermore, that could then "lure" or be utilized in better terms to suck in lower Frequencies.

So dependent on those thoughts this is the idea that I'm exploring, the arrangement with this investigation isn't for consistent activity, But to more readily see how Electrets work and on the off chance that they can be applied with the Kapagen and Tesla thoughts. Everything looks OK!

This L/C circuit self Oscillates for more than 20 minutes.

I utilize the Electret in accordance with where the Light Bulb load would go in accordance with the Kapagen before ground.

furthermore, on the capacitor "Positive" side, This goes to a high Frequency coil Primary then on the opposite side of Primary goes to earth Ground, on the high Frequency coil Secondary, I Rectify and send off to Electret capacitor ordinary Plus and Minus pins. This help with extra charging. I noticed the capacitor charges without this! Extremely intriguing. Yet, this additional stage, speeds the energize time. At the point when Electret comes to around 500 MV. It triggers pcb Joule Thief circuit rather than a Led, it Drives a diode and heartbeats to Primary capacitor stage, the stage in this circuit that runs my high Frequency oscillator and works well at 1 volt input drive.

It is my rough agreement that in this sort of design. this resembles a not all around tuned Scalar charging unit that self Oscillates for quite a while with the assistance of "input" and some assistance with Ambient and Scalar wave "feedback" en route.

I'm certain with some Tweaking. I could make it self supportable for inconclusive time, But I don't see the application here for this particular circuit. However, These outcomes where still exceptionally intriguing, Here is a film of me running it, and recording how long it runs until I chose to execute the high Frequency Oscillator.

Forum:
http://typeright.social/forum

Please Help Support My Research: https://youtu.be/pYXETBB40j0

Loading comments...