Very Beautiful and New Kurti Neck Design Cutting and Stitching

Certainly! I can provide you with a general description of a beautiful and new kurti neck design, along with cutting and stitching instructions. Please keep in mind that it's always recommended to consult a professional tailor or designer for accurate measurements and precise execution. Here's a popular kurti neck design called the "Keyhole Neckline" that you may find attractive:

Materials:
- Fabric of your choice
- Matching thread
- Scissors
- Measuring tape
- Pins
- Sewing machine or needle

Instructions:

1. Measurements and Cutting:
- Measure the circumference of your neck and add an extra inch for ease and seam allowance.
- Decide how deep you want the keyhole opening to be and mark the center point on the fabric's neckline.
- Measure and mark the desired width of the keyhole, centered on the previous mark.
- From the center of the keyhole, measure and mark the desired length of the keyhole.
- Extend the keyhole marks vertically to the desired depth of the neck cut.
- Cut along the marked lines.

2. Finishing the Raw Edges:
- Fold the raw edges of the keyhole and neckline inside by about ¼ inch and press with an iron.
- Fold the raw edges again by another ¼ inch, press, and pin in place.
- Sew a straight stitch close to the folded edge to secure the hem.

3. Creating the Keyhole:
- Fold the fabric along the vertical lines of the keyhole, right sides together.
- Pin the folded edges together.
- Starting from the top of the keyhole, sew a straight stitch along the vertical lines, ending at the bottom.

4. Neckline Binding:
- Cut a strip of fabric for the binding, approximately 2 inches wide and long enough to go around the neckline.
- Place the binding strip on the neckline, right sides together, aligning the raw edges.
- Pin the binding strip in place, stretching it slightly to fit around the curves.
- Starting from the back of the neckline, sew a straight stitch along the raw edges, attaching the binding to the neckline.
- Trim any excess fabric.

5. Finishing:
- Fold the binding strip over to the wrong side of the fabric, encasing the raw edges.
- Press the folded binding.
- Sew a straight stitch close to the inner folded edge of the binding to secure it in place.

Once you've completed these steps, your kurti with a keyhole neckline should be ready! Remember to customize the design and measurements based on your preferences.