GMS Nano Bubble Water Fuel System Drawing Stanley Meyer

This Picture I am Calling Current or Version 5

The Versions

Version 1 was a Choice of either Gasoline and or GTNT gas only, using a common injector in a delrin block

Version 2 was a choice of nano bubble water or gtnt gas, using gas spark adaptors, ( water spark plugs) this used 1 vic round bobbin via distributor

Version 3 was running water through a EPG Box I believe it initially was a way to cool or keep nano bubble water cold, this is when they found out it can make power also as nano bubble water is a magnetic gas also.

Version 4 it highly Likely using multi coil and no distributor.

Version 5 this picture attached is using crank position sensor in replace of distributor but still using the distributor so people can follow the transition. there is no water pump as cell can go to 6 bar and the last pulse pressure raising pressure to atomize at 120 psi from nano bubble water to a fuel gas was done by push solenoids.
So there is no wire from distributor as it is from crank position sensor on this drawing.

We continue drawing various cards and main boards connection's

All the Best
Dan