Homemade Overarm Dust Collection Hood for Table Saw | DIY

My table saw has horrible dust collection, second only to my miter saw. I've been looking at buying an overarm dust collection hood but they're expensive and won't necessarily fit a small job site saw. I decided to make one out of plywood and acrylic. I struggled with the design for a long time but decided enough was enough and I needed to just start building. I'm happy with the outcome although I could probably make some improvements to the dust hood design. After using this version for a while I'll know exactly how to upgrade it later.

T-bolts: https://amzn.to/489l5j1
T-bolt kit: https://amzn.to/3szV1x3
2.5” flexible dust hose: https://amzn.to/44WsL59

🔨 Tool links:
Safety Gear
- Micro jig narrow rip push block: https://amzn.to/3Nl97ZF
- Micro jig paddle push block: https://amzn.to/43Ic9ON
- Milescraft push stick: https://amzn.to/3NDlDoW
- ISOTunes ear protection: https://amzn.to/44aYpMd
Measuring
- FastCap measuring tape: https://amzn.to/3qYM9Ao
- Setup blocks: https://amzn.to/3NFobCZ
Sanding
- Bosch sander: https://amzn.to/3qVilEE
Saws
- Bosch job site table saw: https://amzn.to/46t1nhl
- Bosch track saw: https://amzn.to/43RNS8T
Joining
- wen biscuit joiner: https://amzn.to/3CGt8Fm
Drilling
- Forstner Bit Set: https://amzn.to/3NGbMi8
Other
- auto vacuum switch: https://amzn.to/42SayEE
- 2P10 super glue and activator: https://amzn.to/3Pot7gU
- Bosch dust extractor: https://amzn.to/3PmF8Dk
- WEN air cleaner: https://amzn.to/3JoWj3B