Custom Cutting Foam Inlays | Consumer Grade XTOOL Diode Laser

In today's mini-project we'll be cutting foam with a 20W diode laser. The goal here is to have a custom foam cut out for a hard covered case to house custom knives or tools.

🔸RBO Site - https://redbeardops.square.site/

⭐ Items:
Hard Case - https://amzn.to/45VluU9
1'' Foam - https://amzn.to/3sAxhc5
3M Adhesive - https://amzn.to/3sAxhc5
xTool D1 20W Laser Kit - https://www.xtool.com/products/portable-diode-laserbox-d1-for-laser-engraving-laser-cutting-b?ref=RedBeardOps&utm_medium=4938&utm_source=influencer
xTool Air Assist - https://www.xtool.com/products/xtool-air-assist-set?ref=RedBeardOps&utm_medium=4938&utm_source=influencer

🔸 Become a RBO Patron - https://www.patreon.com/RedBeardOps

🛠 Notable Items and Tools:
Honeycomb Table (400x400mm) - https://amzn.to/3RmYaba
Amazon Link To XTOOL - https://amzn.to/3qsZbCG

Instagram: https://www.instagram.com/redbeardops/
Twitter: https://twitter.com/RedBeardOps
Facebook: https://www.facebook.com/RedBeardOps

#redbeardops
#lasercutting
#laserengraving

**********************************************************
A Notice from Red Beard Ops LLC:
The information provided on this channel is for entertainment purposes only. Any action you as the viewer takes upon the information on this channel is strictly at your own risk, and Red Beard Ops LLC will not be liable for any losses, damages, or personal injuries in connection with the use of this content (including injuries, damages, or losses sustained while you were trying to emulate the actions and projects on this channel). Attempting to emulate any of the actions or projects put forth by this channel should not be done without training and even then, at your own risk.