Quick Mod To Use Any Build Plate On The K1 & K1 Max #3dprinting #creality
This will allow you to use just about any build plate you like with your K1, K1 Max along with other Creality printers that use this same setup.
Here are the free files - https://www.printables.com/model/576118-creality-k1-k1-max-universal-build-plate-alignment
If you are looking for the build plates that I used & tested you can find them below.
Build Plate Upgrades for the Creality K1 MAX:
Creality K1 Max PEI Build Plate - https://amzn.to/3PjjW0N
Ender 3 S1 Plus PEI Build Plate (Will Work With The K1 Max) - https://amzn.to/3r22OmJ
Build Plate Upgrades for the Creality K1:
PEI Double Sided Magnetic Build Plate for K1 - https://amzn.to/449CVQq
PEI Printing Plate Kit With Cutouts like the Original - https://amzn.to/43bIgWb
Creality K1 MAX 3D-Printer(From Creality) - https://bit.ly/Creality-K1-Max
Creality K1 MAX 3D-Printer(From Amazon) - https://amzn.to/45QKzjc
Creality K1 3D-Printer (From Creality) - https://bit.ly/Creality-K1-3D-Printer
Creality K1 3D-Printer (From Amazon) - https://amzn.to/3CXlrdT
________________________________________________
Note : Most of the links that I use that go to products are affiliate link. This means I make a small commission on anything that you happen buy using them. This is at no extra charge to you and this helps support the work I do on this channel. 😁👍
________________________________________________
Creality K1 & K1 Max Universal Build Plate Alignment Stops
#3dprinting #creality #crealityk1 #crealityk1max #3dPrinting #3dScanning #DIY #RandyMay
-
5:48
Randy May
2 years agoQuick & Detailed Review of the Creality Halot One Plus 4k Resin Printer
98 -
12:03
3D Printing Professor
7 years ago3D Printing Basics - How to level your 3D Printer's build plate
4 -
17:09
GarageScience
1 year agoImprove Build Plate Adhesion on Your 3D Printer
16 -
1:59
USSROVER
8 months agobuild plate mod
1 -
6:38
3D Printing Professor
9 years ago3D Printer Mods and Repair
6 -
6:02
ALLCHECKOUT
2 years ago3D Printer Not Printing - Just Moving The Head (TinkerCad, Ultimaker Cura, Anet ET5X, STL Export)
32 -
5:26
medyk3D
4 years agoAssembling Original Prusa i3 MK3S - Part 8: Preflight check (quick version)
-
13:38
3D Printing Professor
3 years agoCan an $80 3D printer be any good? EasyThreed K7 Review
1 -
7:17
GarageScience
1 year agoDIY 3D Printer Case ~ An Easy Enclosure to Improve 3D Printing Quality
58 -
19:21
Tripods Garage
2 years agoKywoo Tycoon Slim 3D Printer - First Look
4