How to Solve Loose PrintABlok Ball Joints

If you've tried 3d printing a ball joint, like the ones use in PrintABloks, you may have run into a problem. The joints start out fine, but over time they loosen. Fortunately there's a couple of solutions you can employ, and Cymon and I will tell you all about them.

3D Printing Professor is made possible by YOU!
https://www.3dpprofessor.com/support/

I'm social!
https://discord.gg/rpwXqE5
https://mastodon.online/@3DPProfessor
https://twitter.com/3DPProfessor
https://www.facebook.com/3DProfessor/

Buy the Beginner's Guide to the 3D Printing Galaxy on Amazon: https://amzn.to/2ws7OiT

Shop on Amazon to support the channel: https://bit.ly/3DPPrinters

Follow my other 3D printing adventures at: https://www.3dpprofessor.com
Join the mailing list and never miss anything important: https://bit.ly/3DPPnews

00:00 Why are my joints loose?
05:13 Solution : Bluetak
06:30 Solution 2 : Swap for Tighter
07:38 Solution 3 : Nailpolish
08:38 Solution 4 : Print in PetG
09:23 3D Print to Win