Push Block CNC Work Hold Clamps
11 months ago
14
To set up your spoil board to use these clamps, create a grid of 2in holes on center. It is recommended to do a test of 4 holes in scrap to ensure proper alignment in the vertical and horizontal positions. Do not use an endmill to drill the holes. What I used and is the suggested bit to use, the Lightning Series ¼" Carbide Drill form IDC Woodcraft.
Get Extreme-Performance with the IDC Woodcraft 1/4 Drill Bit to prep your spoil board for the Push Block Work Hold Clamp https://link.idcwoodcraft.com/hqatlj
Loading comments...
-
2:48:31
Resistance Chicks
5 hours agoBritain Descends Into Chaos! Venezuela on the Brink of Collapse - Olympic Fallout Continues 8/4/24
35.9K22 -
57:06
FULL SEND PODCAST
2 days agoJ.D. Vance Reveals Why Trump Chose Him as VP and Exposes Kamala Harris and the Democrats!
49.5K97 -
2:04
OutdoorChannelTV
3 days agoThe Buck Known as Big Bacon
49.8K42 -
50:06
Standpoint with Gabe Groisman
9 hours agoEp. 40. 116 Hostages. Fleur Hassan-Nahoum
49.6K7 -
56:59
Sports Wars
8 hours agoWoke Olympics SLAMMED As Female Boxers Get DESTROYED By Men | This Is INSANE
55.8K98 -
LIVE
Right Side Broadcasting Network
4 days agoLIVE REPLAY: President Trump and JD Vance Hold a Rally in Atlanta - 8/3/24
4,187 watching -
2:22:53
The Quartering
1 day agoTrump Rally Then Gaming Playing Final Fantasy Online After!
183K40 -
31:55
Stephen Gardner
1 day ago🔴The Trump Shooting Story JUST BECAME extremely suspicious!
192K427 -
7:36:46
Akademiks
1 day agoDrake Announces Album Coming ... DJ Mustard Blames Drake for Low Sales. Big Sean Duckin K Dot?
213K45 -
5:10:55
Drew Hernandez
1 day agoTRUMP RALLY ATLANTA GA & USSS J/13 COVER-UP EXPOSED
192K154