BEST VALUE - Tacoma Lift - Eibach Pro Truck Lift System- Stage 1 DIY Install on 3rd Gen Tacoma

Do you want to put a lift kit onto your truck for off-roading or overlanding. Don't want to drop over 2k on a ICON lift. This is the kit for you.

Check out my full article on trailtacoma.com
https://trailtacoma.com/2020/02/26/eibach-pro-truck-lift-install-3rd-gen-tacoma/

This lift system is the closest for a factory ride that I have driven to date. Looks good, feels good, more ground clearance and for under 1,000 dollars.

Here are some important features about the Eibach Pro-Truck Lift System.

-The Eibach front coilover is fully adjustable by using the C-clip rings on the shaft of the front shock.

-The bottom ring is 2" and the middle ring is 2.5"ish. The very top ring is recommended if you have extra front end weight more than 150 pounds.

-Again, the stage 1 kit is the front coils, front shocks and rear shocks. The rear blocks and longer U-bolts are sold separately.

-Fun fact, apparently you can retrofit the Eibach Coils on the Bilstein 5100's.

Eibach Pro-Truck Lift System (Stage 1) Toyota Tacoma
https://eibach.com/us/i-8816-pro-truck-lift-system-stage-1.html

Eibach Pro Truck Rear Lift Block Toyota Tacoma
https://eibach.com/us/i-12135-pro-truck-rear-lift-block.html

I installed this in my garage with a combination of hand tools and air tools in about 6 hours.

Some of the tools and specialty tools I used;
Metric Socket and Wrench
https://amzn.to/2wzxvmG

Snap Ring Tool
https://amzn.to/3cc8JJU

Needle Nose Pliers
https://amzn.to/2Vn6Q7f

Vice Grips
https://amzn.to/2ViLyY3

Floor Jack
https://amzn.to/39QVn3I

Jack Stands
https://amzn.to/39ZKuwC

Magnet Tool Tray
https://amzn.to/39WNycB