Lumber Mill 002 The Motor

A Lumber Mill needs a good motor, right!? Right! After looking through the motors I have around I found one that should be excellent for a lumber Mill. It's a 36V 4.15HP 24VDC electric motor. I'll probably run it at around 30V so it'll be around 3HP which should be good for cutting. Oh, and it's 2300RPMs at full power which is acceptable. Only one problem... it doesn't spin around when I put electricity into it. Hmmm... Luckily, I have a little elf assistant to help me fix it!

Send me an email! theadventurebuildermovie@gmail.com

Help out:
Adventure Builder Club Shirts and Mugs and Stuff (Feel free to make requests): http://shop.spreadshirt.ca/1079802/

Patreon: https://www.patreon.com/jmemantzel

PayPal: https://www.paypal.com/donate/?hosted_button_id=N6YSG4J7ZL5RG

Bitcoin: 1GPLqw2h5fLPTNyQviiAawc1n7UPHPBHdB

Amazon Wishlist!: https://www.amazon.com/hz/wishlist/ls/17SE3OH6ZA18J?ref_=wl_share

YouTube Membership: https://www.YouTube.com/jmemantzel/join

Big hugs, and Thank yous to all the Adventure Builders out there and everyone else who's been so supportive over the years! Jaimie