Kenneth Wells Stationary Engine - 14 - The Piston, Connecting Rod and Big End
1 year ago
16
Kenneth Wells
Kenneth Wells engine
kenneth wells stationary engine
kenneth wellls stationary steam engine
kenneth wells steam engine
steam engine
shop project
metal shop
metal shop project
beginner metal shop
beginner metal shop project
In this episode I finish up the last of the engine components, which includes the piston, the connecting rod and big end. The stationary engine gets assembled and a little test run on air. Before I can carry on with this build I need to make a boiler test rig, which includes a hand water pump and a safety relief valve. Stay tuned ...
Loading comments...
-
26:29
My Heap
1 year agoKenneth Wells Stationary Engine - 07 - Firebox Sides, Boiler Strap and Tie Rods
11 -
24:05
My Heap
1 year ago $0.01 earnedKenneth Wells Stationary Engine - 12 - The Engine Cylinder
15 -
0:29
Myrickman
11 months agoFreelance horizontal opposed piston model; 3/4” bore
33 -
14:55
Mountain Views Garage
2 years ago2007 Ford F250 4x4 Powerstroke 6.0 Diesel Project Part 2
124 -
1:20:51
Jhaberl40
1 year ago1974 Norton Commando engine bottom end rebuild, Part: 5 Fitting the pistons and cylinder assembly
31 -
5:24
Whitetail Garage
1 year agoHow To: Installing 302 Piston Rings
8 -
0:34
Myrickman
2 years agoMyrick 5hp forge blower antique engine
44 -
25:39
2HacksGarage
1 year agoEasy! How to Install Pistons onto Connecting Rods and Gap Piston Rings on a SBC! #howto
15 -
5:51
Daze of Glory Shopworks
2 years agoCheap 440 Build Pt15, Talking piston and connecting rod orientation
17 -
20:51
Nutter's Speed Shop
3 years ago $0.01 earnedTXL Part 2 Bore and Hone in a home shop
624