Kenneth Wells Stationary Engine - 13 - The Pivot Plate Assembly
1 year ago
11
Kenneth Wells
Kenneth Wells engine
kenneth wells stationary engine
kenneth wellls stationary steam engine
kenneth wells steam engine
steam engine
shop project
metal shop
metal shop project
beginner metal shop
beginner metal shop project
In this episode I make the Pivot Plate and in doing so learn a very important lesson about drilling brass, especially if it already has a pilot hole. Along with the pivot plate is the knurled adjusting nit and pivot pin that attaches to the cylinder and a couple of studs.
Loading comments...
-
40:44
My Heap
1 year agoKenneth Wells Stationary Engine - 11 - More Frame Work and the Crank Assembly
15 -
18:54
My Heap
1 year agoKenneth Wells Stationary Engine - 10 - The Engine Frame
11 -
1:21:12
Jhaberl40
2 years ago1971 Triumph Tiger restoration, Part 9 Installing the cylinder and pistons
342 -
10:36
Jhaberl40
5 months ago1968 Triumph Bonneville restoration Part 2, Installing a tapered neck bearing conversion kit
23 -
24:45
Woods Creek Workshop
3 years ago $0.01 earnedLATHE SPINDLE BEARINGS (Part 1) - TEARDOWN of 13x40 Engine Lathe Headstock
1853 -
32:38
Woods Creek Workshop
3 years ago $0.04 earnedLATHE SPINDLE BEARINGS (Part 2) - REASSEMBLE AND TEST of 13x40 Engine Lathe Headstock
3672 -
6:33
Sailing sv Little Bear
3 years agoChain plate removal Pt.2
9 -
38:21
westerntruckandtractorrepair
3 years ago367 peterbilt engine mounts
12 -
14:27
Keith Fenner, Career, Hobbies and Life
1 year ago $0.01 earnedOshkosh rear axle tube Part 2
602 -
21:35
Hersch_Tool
1 year ago $0.02 earnedMachining and Fitting an L0 Back Plate
513