Premium Only Content
This video is only available to Rumble Premium subscribers. Subscribe to
enjoy exclusive content and ad-free viewing.

Kenneth Wells Stationary Engine - 08 - Finishing the Firebox and Making the Boiler Parts
2 years ago
14
Kenneth Wells steam engine
steam engine
stationary steam engine
kenneth well stationary steam engine
lathe work
lathe turning
lathe drilling
pressure turning
metal forming
boiler
boiler end plates
In this episode, I finish up with the firebox sides by dishing the vent holes. From there I make the parts required to make the boiler for the engine. I do some turning and other metal lathe work along with some copper annealing and boiler flanging.
Loading comments...
-
17:34
My Heap
2 years ago $0.03 earnedKenneth Wells Stationary Engine - 06 - The Firebox Ends
12 -
26:29
My Heap
2 years agoKenneth Wells Stationary Engine - 07 - Firebox Sides, Boiler Strap and Tie Rods
14 -
33:20
My Heap
2 years agoKenneth Wells Stationary Engine - 05 - Finishing the Burner Assembly
5 -
5:26
My Heap
2 years agoKenneth Wells Stationary Engine - 01 - Introduction
12 -
18:10
My Heap
2 years agoKenneth Wells Stationary Engine - 02 - The Base
113 -
25:20
My Heap
2 years agoKenneth Wells Stationary Engine - 03 - The Fuel Tank
6 -
37:50
My Heap
2 years agoKenneth Wells Stationary Engine - 04 - Wick Tubes, Fill Tube and Supply Pipe
5 -
0:07
jimsDIYgarage
2 years agoMaking engine milkshakes
6 -
LIVE
Barry Cunningham
12 hours agoDON'T MISS TODAY'S WHITE HOUSE PRESS CONFERENCE WITH KAROLINE LEAVITT (AND MORE NEWS)
1,993 watching -
UPCOMING
IrishBreakdown
1 hour agoBig Ten/ACC Going After The SEC - Notre Dame Buy/Sell/Hold
2