BACKYARD FIBERGLASS BOAT BUILDING | Part 2

Save
5 years ago
62

SKIFF PARTS & SUPPLIES LISTED BELOW
(FGCI Main Site) http://bit.ly/FGCI-HOMEPAGE
(FGCI Amazon Site) http://bit.ly/FGCIProducts
General Purpose Polyester Resin (Part#128776)
Clear MEKP Catalyst (Part#132663)
1208 Biaxial Fiberglass (Part#137312)
Chop Strand Mat Fiberglass (Part#125722)
Red MEKP Catalyst (Part#132676)
Lightweight Polyester Putty (Part#133664)
Douglas Fir Marine Plywood (Purchased At Lowes)
Deck Hatches: https://amzn.to/2pbrDMI

OTHER PRODUCTS MENTIONED
On The Fly Jack Plates: https://www.ontheflyjackplates.com
1997 Yamaha 25hp 2-Stroke Short 15" Shaft (purchased used)
PWC Doctor Versiplug #1501: http://bit.ly/VersiPlug
Fuel Water Separator: https://amzn.to/3aJgwPB

TOOLS USED
My Occilating Tool (expensive): https://amzn.to/33iRpNP
Other Occilating Tools (cheaper): https://amzn.to/35qpsp9
Drill: https://amzn.to/313jJCn
Mixer Attachment: https://amzn.to/2OCnNXU
Fiberglassing Starter Kit: https://amzn.to/2VsP3JK

Boat building is a blast! A little bit of DIY, plywood , and fiberglass can make you a fun little boat! I knew nothing about fiberglassing & rebuilding a boat but I was able to tackle this project! If I can do it so can you! I had looked at several small fiberglass skiffs like the Johnsen skiff, Gheenoe, and more! You can find great deals on these little microskiffs. I found tons of similar skiffs for under $500! Some Johnsen skiffs can even be found for $100 via FB marketplace...and they are very similar in design to my Mitchell Flats Skiff.
So stay tuned to the channel as I continue to TRICK MY SKIFF!
Also, Don't forget to check out my friend SeaSic's Channel!
#skifflife #microskiff #skiff

**ALL MUSIC IN VIDEO IS LISTED BELOW**

Island by MBB https://soundcloud.com/mbbofficial
Creative Commons — Attribution-ShareAlike 3.0 Unported— CC BY-SA 3.0
Music promoted by Audio Library https://youtu.be/6by8zhaG04Y

Last Summer by Ikson: http://www.soundcloud.com/ikson
Music promoted by Audio Library https://youtu.be/n2oTA5JSk80

Club by Andrew Huang (YouTube Audio Library)

Loading comments...