P-51 Mustang RC Plane Build and Fly

3 years ago
27

I redesign this RC foam board P-51D Mustang from the original plans that I made for papermodel. I simplify the design for easier building. The main material is still 5mm depron or polyfoam foam board. In this project it's the first time I use 4 of these new techniques. They are DIY spinner, new clear canopy molding, laminating film for covering and DIY retractable landing gear. I'm quite satisfied with all the result, except the landing gear still needs more improvement but, it has lots of potential. Although it worked but still, I will improve it in future projects. This Mustang is fast, even with just 50% throttle, I was trying hard to not hit a tree when flying it. I should add flaps for slower landing, but the time for this project is limited so I'll leave it to you to improvise with this plans, good luck and have a good building time.

SUBSCRIBE dan Like untuk support channel ini
#rcplane #rcmustang #rcwarbird #buildvideo #mustang #warbird

You can download the plans on the link below :
A4 Plans : https://paper-replika.com/RCplans/PR_Mustang_A4.pdf
A0 Plans : https://paper-replika.com/RCplans/PR_Mustang_A0.pdf
A3 Decal : https://paper-replika.com/RCplans/Ferocious_Frankie_Decal.pdf

Build instructions :
https://paper-replika.com/index.php/rc-foam-project/p-51d-mustang-rc-plane

DONATE via Paypal : Juliusperdana@yahoo.co.id

Playlist :
00:00 Intro
03:12 Plan Preparation
04:22 Landing Gear
07:32 Wing
14:44 Fuselage
19:06 Spinner
22:27 Installing Motor
23:58 Stabilizers
25:55 Covering
29:26 Wing Mounting
30:24 Tail Section
36:56 Servo and Pushrod
39:51 Color Scheme and Decal
42:15 Clear Canopy
47:42 Finishing Up
49:39 Maiden Flight
58:08 Review

Specs :
1. Wingspan 1100mm / 43.3 inches
2. Flying weight : 1060 grams/ 37.4 oz
3. Wing loading : 47.5 gram/dm2 - 15.6 oz/sq.ft.
4. Wing cube loading : 10
5. Wing Area : 22.3 dm2 / 346 sq.in.
6. CG : 4 cm

Electronics
- motor 35 - 650kv - 1200kv brushless motor
- Tested with DXW 3536 1200kv brushless motor prop 10x6x3
- ESC 50A
- Battery Lipo 3S 2200mah
- 4 metal gear 9 gram servos (micro servo)
- 1 metal gear standard servo

Materials :
1. 5mm Depron/ Polyfoam
2. 3mm + 7mm Plywood
4. 0.3mm + 0.5mm Mica Plastic
5. hot glue, UHU glue, CA glue
6. laminating film https://amzn.to/3leCsqK

Tools :
1. Covering iron https://amzn.to/38YZyMh
2. Heat gun https://amzn.to/3A1cvkR
3. Hot glue gun https://amzn.to/38XyrkY

Loading comments...