Making RC Douglas DC-3 Part 1

About 2 months ago I held a polling on my community tab, to decide between Douglas DC-3 or DHC-6 Twin Otter, the winner for the next twin motor RC model plane is Douglas DC-3. This project should have began last week but I ran out of 3mm foam board. I mainly use 3mm depron foam or polyfoam for the material and 5mm for the formers. The wingspan will be 2200 mm or 87 inches. This project will be devided into 3 or 4 parts, from start to finish and fly. In between each part I will make 2 new projects, so it will not too boring on just 1 subject.

SUBSCRIBE and Like to support this channel
#dc3 #rcplane #buildvideo

Playlist :
01:09 Plans Preparation
02:04 Nose Section
08:31 Fuselage
12:54 Vertical Stabilizer
16:17 Next Project?

You can download the plans on the link below :
A4 Plans : https://paper-replika.com/RCplans/PR_DC-3_Part1_A4.pdf
A0 Plans : https://paper-replika.com/RCplans/PR_DC-3_Part1_A0.pdf

Build instructions :
https://paper-replika.com/index.php/rc-foam-project/douglas-dc-3-rc-plane-part-1

DONATE via Paypal : Juliusperdana@yahoo.co.id

Specs :
1. Wingspan 2200mm / 87 inches
2. Flying weight : -
3. Wing loading : -
4. Wing cube loading : -
5. Wing Area : 25.2 dm2 / 391 sq.in
6. CG : -

Electronics
- 2X Turnigy 2830 1000kv brushless motor
- ESC 40A
- Battery Lipo 3S 2200mah - Li-ion 3S 3300 mah
- 4 plastic gear 9 gram servos
- 5 metal gear 9 gram servos
- Propeller : 9x6x3

Materials :
1. 5mm & 10mm Depron/ Polyfoam
2. 3mm Plywood
4. 0.3mm Mica Plastic
5. hot glue + CA glue + UHU glue
6. wax paper

Tools :
1. Covering iron https://amzn.to/38YZyMh
2. Heat gun https://amzn.to/3A1cvkR
3. Hot glue gun https://amzn.to/38XyrkY