LTEM-PA/LTEM-PV: Install PROWIFI or PROWIFIZW

In this video, Julia from Alarm Grid shows users how to install the PROWFI or PROWIFIZW into an LTEM-PA or LTEM-PV communicator. The first thing you should do is power the system down by unplugging the DC power adapter and then removing the cover and unplugging the battery.

To remove the cover, use a small screwdriver to press in the locking tabs on the bottom edge of the LTEM-P communicator, and then pull the cover up, or forward and lift it out of the way. Now you can unplug the positive lead for the battery to power the device completely down. All of the LEDs on the unit should be off.

The PROWIFI or PROWIFIZW installs in the upper left corner of the main communicator board. There is a piece of foam tape on the back of the communicator. Be sure to leave this in place. If the LTEM-P series communicator has a piece of foam on the plastic, one that will be located beneath the PROWIFI or PROWIFIZW after it's installed, this piece of foam should be removed.

Line the edge connector of the LTEM-PA or LTEM-PV up with the port on the back of the PROWIFI or PROWIFIZW. There is a plastic locking tab located on the LTEM-P communicator that the board of the PROWIFI will snap under when it's installed correctly. Once the board is lined up with the connector, slide it forward until it snaps into place on the edge connector. The PROWIFI or PROWIFIZW will be held in place by the connector on the back, and by the plastic locking tab at the top.

Plug in the DC power adapter, plug in the battery, and replace the communicator's cover. The communicator should power up and be ready to activate.

https://www.alarmgrid.com/faq/how-do-i-install-the-prowifizw-in-a-ltem-pa-or-ltem-pv

http://alrm.gd/get-monitored