2 years ago

This video is the overview of the prep work before building the machine for the dust collection.

All parts have foil tape to help reduce static on both the inside and outside of the tubes.
Negligible risk, but with electronics involved, better safe than sorry.

Pretty excited how it turned out.
The wood used was literally off the scrap pile at home depot for 30 cents.
Video explains the all-thread anchors I built, which have a very nice adjustable feature.
5/16" all-thread.
Now all the overhead work is done, I can resume the machine!

[3' clear tubing] (https://amzn.to/41VQTEw)
[4" rubber gaskets] (https://amzn.to/3Vjv8vI)
Used this gasket to match the 3" ABS fittings at Home Depot to. Worked out pretty good.
Probably not a bad idea to taper down a bit after a long run anyhow.
[Flexible Hose] (https://amzn.to/41SiYME)
[Hose Clamps] (https://amzn.to/3HoX0bS)
[Blast Gate] (https://amzn.to/3oN5Rh8)
[copper wire 18 gauge] (https://amzn.to/446eDae)
[Foil tape] (https://amzn.to/40OgKfV)