Flashforge Dreamer (NX) - FilaCube White PLA2 1.75mm Filament Testing - Part 2

This two-part video shows the testing of FilaCube White PLA2 1.75mm Filament.

Part 1 shows unboxing, and using a Temperature Tower to evaluate the best extrusion temperature to use. It also goes over my system for feeding the filament from the side reel loader on the outside into the printer and on to the printhead. And it covers my method for bed leveling using a 3"x5" paper index card.

Part 2 shows a Bed and Layer Adhesion Test to evaluate the best bed temperature and cooling profile to get the best results. Then it prints a white ghost for Halloween!

Link to FilaCube White PLA2 Filament 1.75mm on Amazon:
https://smile.amazon.com/White-PLA-1-75-Filament-Compatible/dp/B0777MQTRK/

Link to Temperature Tower Thingiverse Project:
https://www.thingiverse.com/thing:4356906

Link to Bed Adhesion and Layer Cracking Test
https://www.thingiverse.com/thing:4536632

Link to Ghost on Thingiverse:
https://www.thingiverse.com/thing:4966110

These are the spatulas I used to help remove the pieces from the print bed:
https://smile.amazon.com/gp/product/B075SLTY8B/

These are the tweezers I used to help remove dripping filament from the print head:
https://smile.amazon.com/gp/product/B0845SKD7Z/

This is the wire brass brush I use to clean the nozzle tip:
https://smile.amazon.com/gp/product/B01J2BS92S/

Flashforge Dreamer NX on Amazon:
https://smile.amazon.com/gp/product/B07DPBRCYZ/

OpenSCAD website:
https://www.openscad.org/

I used Simplify3D slicer software for the test:
https://www.simplify3d.com/

-------------------
Link to my Etsy Store:
https://www.etsy.com/shop/BetaCygniDesigns

---------------------
Music:
"Blippy Trance" Kevin MacLeod (incompetech.com)
Licensed under Creative Commons: By Attribution 4.0 License
http://creativecommons.org/licenses/by/4.0/

---------------------
End Screen Video Acknowledgement: Cosmic Reef Video produced by NASA and the Space Telescope Science Institute (STScI).
https://hubblesite.org/contents/media/videos/2020/16/1277-Video