PushBlock Work Hold Clamp For My CNC Router Talbe
1 year ago
393
I designed these to fit a 2X2 inch grid of 1/4 inch holes on my CNC router table.
To set up your spoil board to use these clamps, create a grid of 2in holes on center. It is recommended to do a test of 4 holes in scrap to ensure proper alignment in the vertical and horizontal positions. Do not use an endmill to drill the holes. What I used and is the suggested bit to use, the Lightning Series ¼" Carbide Drill form IDC Woodcraft.
Get Extreme-Performance with the IDC Woodcraft 1/4 Drill Bit to prep your spoil board for the Push Block Work Hold Clamp https://link.idcwoodcraft.com/hqatlj
Loading 1 comment...
-
19:37
JackInTheShop
10 months agoPush Block CNC Work Hold Clamps
14 -
5:35
JackInTheShop
1 year agoPrototype Of My Push Block Design For CNC Work Hold
12 -
14:18
WoodWorkWeb
9 years agoHow to Make a Router Table Top - Woodworking Router Series
1 -
0:29
Delta-Tool - Inventions for a better life
4 months agoRouter table plate on the Bosch GTS 254 table saw for Bosch POF router with router lift
7 -
10:23
DIY Creators
4 years agoWall mounted storage rack for clamps ( DIY Woodworking )
64 -
0:47
Delta-Tool - Inventions for a better life
4 months agoMilling table with limit stop for Bosch, Festool, Makita, Triton and Einhell routers
10 -
11:44
WoodWorkWeb
10 years agoHow to Make a Router Circle Jig - a woodworkweb
16 -
12:37
WoodWorkWeb
9 years agoMake a Router Table Stand - woodworkweb
5 -
12:36
DIY Creators
3 years agoHow to make and use a simple trim router table
176 -
10:17
WoodWorkWeb
5 years agoHow to Make a Plunge Router Inlay with Wood Router Bushings
18