EVAP Canister Purge Valve Replacement 2011-2017 F150 5.0L

In this video I go over how to replace the evaporative emissions canister purge valve (evap canister purge valve) on the 2011-2017 Ford F150 equipped with the 5.0L coyote engine. The procedure is rather simple. First, disconnect the electrical connector. Then disconnect the evap line from the valve. Then unbolt the valve from the intake manifold. Pull the valve away from the intake while twisting back and forth slightly. The installation is the reverse procedure.

Note: If your check engine lamp was on due to a faulty valve then you will need to have the codes erased to clear the check engine lamp. This can be done with a scan tool. If the light comes back on and the same code sets after replacing the valve then the root cause was not corrected and further diagnosis will be needed.

Note: when using the word "evap" it is short for "evaporative emissions".

DISCLAIMER
Barbour's Auto Help is not responsible for any damage or personal injury incurred in the process of performing any auto repairs done by you the viewer. Automotive repair is extremely dangerous. Repair your vehicle at your own risk. It is the viewers responsibility to verify all information and procedures as outlined in YOUR REPAIR MANUAL AND OWNERS MANUAL FOR YOUR VEHICLE. Owning and using a repair manual suited for your vehicle is essential for correctly and safely performing ANY repair to your vehicle. Always wear safety glasses, protective gloves and heed all instructions for use applicable to any piece of equipment you may use. Due to circumstances out of the control of Barbour's Auto Help, Barbour's Auto Help makes no guarantee that by the use of the information given in this video a quality repair will be made. Barbour's Auto Help makes no guarantee that the information provided is totally complete, synchronized and accurate. Verify everything using an appropriate repair manual. Verify everything with your own research.