5.3 LM7 - Fire Up and PCM Troubleshooting
1 year ago
17
I filmed this in 2017 while I was working on a 2000 GM LM7 engine (LSX) for a swap into a '74 Chevy K10. I modified the stock wiring harness and used HP Tuners to remove VATS from the stock PCM. It took some troubleshooting to figure out why the engine would not run after my first attempt at removing VATS. It was good to finally hear it run!
Disclaimer: You assume all responsibility for what YOU do. In this video, I am simply showing what I DID. Running an engine on an engine stand is not good practice.
Loading comments...
-
1:33
SinisterP
1 year ago $0.23 earnedInstalling the GMM66 piggy-back adapter into your GM ECM/PCM
89 -
0:47
Thorwon58
2 years ago1987 YJ 2.5L running on a 0411 GM PCM
35 -
1:13
JackOfAllMasterOfNoneAK
2 years ago $0.01 earnedTurbo Charged LS Swapped 1964 C10 First Fire- Sloppy Stage 2 Cam
81 -
8:02
BMW DIYs and Reviews
2 years agoFix BMW Engine Shake | F30 Motor Mount DIY | 328i 3 series
101 -
0:42
SinisterP
10 months agoPROM chip install into a GM ECM
9 -
2:30
Modern Muscle Xtreme
2 years ago2009+ 5.7L Hemi and 6.4L 392 Hemi Engine PCM for your Resto-mod
55 -
21:14
davidgpo
1 year agoRepairing a Coleman model 220 Double Mantle Lantern
51 -
0:32
Thorwon58
2 years ago1988 4.0l Jeep engine running on a GM PCM.
361 -
5:04
Theodore Panteliadhs
1 year agoBMW M43B16 Disassembly & Diagnose
10 -
6:29
Next Life Garage
3 years agoTurbo 240sx Fuel/Ignition Controller Recalibration
5