Sheet Metal Hull DONE - Tracked Amphibious Vehicle Build Ep. 18

5 years ago
18

This DIY tracked amphibious all terrain vehicle project has come along nicely - the watertight hull design is now done. There will be no more shape alterations, although the engine exhaust pipe has to be routed through one of the side panels I just made in this video. I fiddled around with rear seat ideas and came to conclusion that the simplest solution must be the best. So no car seats for the rear. I made a tunnel / cover for the propshaft but running out of sheet metal made it look not perfect. And again - using my homemade sheet metal brake / bender for all the bending in the video. The design of the brake leaves a lot to be desired but it does the job. An update on it is a must. I hope you enjoy! Thanks for watching!

#donndiy #homemade #trackedvehicle

This video is part of a series of videos, check out the series here: https://www.youtube.com/watch?v=vNDiAHNykoY&list=PLkmF7FAZBzkWdzAxcrnz-WJbzSRyqrSBt

Check out my other videos on my channel page: https://www.youtube.com/c/DonnDIY

Soundtrack:
Pomade - Silent Partner (YouTube Audio Library)

Welding equipment borrowed from Spetselektroodi AS, Estonia:
Fronius TransSteel 2700 welder
Optrel Crystal 2.0 Welding Helmet
Hypertherm Powermax 45 XP plasma cutter

Loading comments...