How to Tune a Contractor Table Saw
9 years ago
2
In this video I show you the steps I take to perfectly tune my contractor table saw. You will need to get or borrow a dial indicator to complete this task.
I first adjusted the trunnions to align the blade with the miter slots, and then I adjusted the rip fence to be aligned with the miter slots. Final results were a perfect alignment with only 0.003" run-out from front to back (a piece of paper is around 0.004" for some perspective.)
Subscribe for more DIY videos
http://bit.ly/2UJxXZW
Music:
"Lucky Day" downloaded from the YouTube Audio Library
Loading comments...
-
12:59
House Doctor Ray
1 year agoMiter Saw Calibration
8 -
0:12
toolgirlsgarage
5 months agoTable Saw + Miter Gauge = Perfect Cuts!
2 -
4:47
ToolReviewZone
1 year ago $0.01 earnedIf you use a Miter Saw or Table Saw you ABSOLUTELY NEED TO SEE THIS TOOL!
23 -
9:24
MikeL90
3 years ago $0.02 earnedTearing Into FREE 10 Inch Delta Table Saw
129 -
13:03
WoodWorkWeb
13 years agoWoodworking - Band Saw Setup and Tuneup
-
11:47
WoodWorkWeb
5 years agoIncra MITER 1000SE: Table Saw Miter Gauge Set Up & Review
9 -
9:24
The Weekend Builder
1 year agoFold Away Miter Saw Station and Assembly Table!
21 -
25:00
rmorgan114
3 years agoHomemade Table Saw — Making The Ultimate DIY Table Saw
75 -
0:33
PENNTOOLCO
11 months agoTest cut on the Dake 370 PP Automatic Ferrous Cold Saw
-
12:05
Ducati 900SS Bevel
1 year ago4x6 Bandsaw - Best Vertical Table Mod