Wood Turning Bark Stripes

This project was more of an experiment than really trying to make a specific thing. I wanted to woodturn a vase, but leave a stripe of bark in the middle. The problem was the wood was oblong, which means it was never really balanced. So hollowing was a pain. I will probably try this again at some point, but maybe with a smaller stripe.

My tools:
TotalBoat Resin: http://www.totalboat.com/product/high-performance-21-epoxy-kits/
Finishing Oil: https://amzn.to/2oAFPP6
Carbide Chisels: https://amzn.to/2NUiEdq
Face Shield: https://amzn.to/2Ac4Cvj
Center Finder: https://amzn.to/2ld06Ju
Jet Lathe: https://amzn.to/2qG2wD5
Nova Chuck: https://amzn.to/32tJvkm
Miter Saw: https://amzn.to/2ZpjuBW
Drill: https://amzn.to/2XtnW0G
Square: https://amzn.to/2VaCNzW
Clamps: https://amzn.to/2UvPSiZ

*if you shop through these links I may receive a small commission. The price is the same for you, but it helps support me as a beginner woodturner in my quest to get a bigger lathe to make bigger projects, and I really appreciate it!

#woodturning
#woodworking
#resin