Flashforge Dreamer (NX) - FilaCube Mint Blue PLA Filament Testing

This video shows the testing of FilaCube Mint Blue PLA 1.75mm Filament using a Temperature Tower, Bed and Layer Adhesion Test, and a 3d Wave that holds a 3d Benchy boat.

Link to FilaCube Mint Blue PLA Filament 1.75mm on Amazon:
https://smile.amazon.com/gp/product/B076Z1KL8K/

Link to Temperature Tower Thingiverse Project:
https://www.thingiverse.com/thing:4356906

Link to Bed Adhesion and Layer Cracking Test
https://www.thingiverse.com/thing:4536632

Link to the 3d Wave that holds a 3d Benchy boat on Thingiverse:
https://www.thingiverse.com/thing:3002446

Here's a link to the Star Wars coin on my Etsy store that uses this filament:
https://www.etsy.com/listing/982393867/star-wars-cyan-crystalline-vertex-coins

These are the spatulas I used to help remove the pieces from the print bed:
https://smile.amazon.com/gp/product/B075SLTY8B/

These are the tweezers I used to help remove dripping filament from the print head:
https://smile.amazon.com/gp/product/B0845SKD7Z/

This is the wire brass brush I use to clean the nozzle tip:
https://smile.amazon.com/gp/product/B01J2BS92S/

Flashforge Dreamer NX on Amazon:
https://smile.amazon.com/gp/product/B07DPBRCYZ/

OpenSCAD website:
https://www.openscad.org/

I used Simplify3D slicer software for the test:
https://www.simplify3d.com/

-------------------
Link to my Etsy Store:
https://www.etsy.com/shop/BetaCygniDesigns

---------------------
Music:
"Blippy Trance" Kevin MacLeod (incompetech.com)
Licensed under Creative Commons: By Attribution 4.0 License
http://creativecommons.org/licenses/by/4.0/

---------------------
End Screen Video Acknowledgement: Cosmic Reef Video produced by NASA and the Space Telescope Science Institute (STScI).
https://hubblesite.org/contents/media/videos/2020/16/1277-Video