Q3 Charge Accelerator Timing Disk & Bearing Plate Assembly
Assembly of the Q3 Charge Accelerator continues with the bearing plate, electronics controls and some more wiring. Read the full article: http://www.thedoityourselfworld.com/articles/article.php?id=11404
I was tired so I spent some time working on more mechanical parts of the charge accelerator which is essentially a pulse motor battery charger. This should restore lead acid batteries faster than my little Bedini motor when tuned properly.
I put together the magnet timing disk. This is a disk with a hub which sits on the end of the shaft of the motor. The magnets will pass a reed switch and turn on the relay to pulse the motor. You can adjust the timing in two different ways on this device. By advancing or retarding the timing or by moving the reed switch closer or farther away.
I put the bearing in the back part of the motor frame. To get it into its seat firmly I actually put it on the floor and used my knees to press it into place all the way around evenly. This worked quite well.
I put the shaft through the bearing so that I could get a feel for how this motor is going to come together. I also put a couple bolts through the frame to hold it upright.
I also put one of the coil stator halves onto the motor to see how it is going to look when assembled.
Thanks for watching. Please Subscribe & follow my daily videos.
Troy
http://www.thedoityourselfworld.com
http://www.theoffgridproject.com
Note: Copying this video, in part or in full, is a violation of copyright unless the user has express permission from the owner. Violation of this copyright will be pursued to the fullest extent of the law.
-
15:01
The Do It Yourself World
7 years agoFinishing Q3 Pulse Motor Stator Wiring & Partial Assembly
27 -
17:58
The Do It Yourself World
7 years agoStarted Assembly Of The Quanta Magnetics Q3 Charge Accelerator
4 -
4:45
CR Components
1 month agoFinal Drive Bearing Races & Gear Ring Installation | Torque Hub Version
-
20:08
Barbour's Auto Help
1 year agoRear Hub Bearing Assembly Replacement 07 Ford Edge 3.5L N/A Front Wheel Drive
21 -
10:30
Workshop Addict
5 years agoWhat To Expect From The DEWALT ATOMIC Series 20 -Volt Drill & Impact Driver
27 -
14:16
4DIYers
7 months agoHow to Replace the Front Wheel Bearings on a Dodge Ram 1500 4wd
155 -
3:10
Mechanic Secrets
3 years agoInfiniti QX56 Upper and Lower Control Arm Replacement in 3 Minutes
77 -
28:35
Banks Power
3 years agoAssembling our Allison transmission | BANKS BUILT Ep 17
1 -
13:01
Banks Power
3 years agoEngineering a Custom 8-lug Rear Axle! | BANKS BUILT Ep 6
6 -
12:43
Humble Mechanic
6 years agoHow To Properly Time and Install Timing Chains on a VR6
14