Flashforge Dreamer (NX) - Replacing the NOISY Fans - Save Your Ears!

In this video I show how to replace the noisy fans that come with the Flashforge Dreamer (NX).

My printer is in my garage, so I don't hear it all the time, but when I'm there, the fan noise (~82dB) was annoying and dangerous over time. Anything over 70dB is considered harmful depending on how long you hear it:
https://www.noisyplanet.nidcd.nih.gov/parents/too-loud-too-long

Save your ears!

There's two of them and they are 80mmx80mm 24VDC fans that're very thin (15mm), which is not a typical PC case fan size or voltage.

But I was able to find a quieter replacement on Amazon that actually has a higher flow rate (Cubic Feet per Minute) so it should provide as good or better cooling.

The cooling in the cabinet is controlled by the printer using a thermocouple as a measurement.

Link to GDSTIME 80mm x 80mm x 15mm 24V DC Brushless Cooling Fan Sleeve Bearing (you need 2):
https://smile.amazon.com/gp/product/B07RY7HC7W/

Flashforge Dreamer NX on Amazon:
https://smile.amazon.com/gp/product/B07DPBRCYZ/

-------------------
Link to my Etsy Store:
https://www.etsy.com/shop/BetaCygniDesigns

---------------------
End Screen Video Acknowledgement: Cosmic Reef Video produced by NASA and the Space Telescope Science Institute (STScI).
https://hubblesite.org/contents/media/videos/2020/16/1277-Video