Engine cradle built, shifter installed and it runs through the gears just fine.
1 year ago
7
We need to roll the complete engine and transmission under the car, then left it into place. We can buy a pre fabricated stand, but decided to fab up this temporary stand. Once complete we can disassemble the stand and use the wood for something else. We built up some rear supports and lowered the engine into the k Frame. There are a couple spots that need to be ground down for clearance but otherwise this seems to work well.
We also mount the shifter onto the tkx transmission, check the input and output spins without the resistance and the shifter moves without binding.
Next up is to remove the pilot bearing, mount the flywheel and clutch. Measure the clearance of the fingers on the clutch to throw-out bearing after the housing is mounted.
Loading comments...
-
20:00
Mr Cuda
1 year agoWe build an engine stand, mount the shifter.
2 -
10:16
Roy's Moto Ventures
7 months agoNEW SHIFTER LINKAGE FOR MY 2021 HARLEY DAVIDSON ROAD GLIDE LIMITED
22 -
9:15
Humble Mechanic
6 years agoHow to Install a Short Shifter and Adjust Shift Cables
-
4:45
CR Components
1 month agoFinal Drive Bearing Races & Gear Ring Installation | Torque Hub Version
1 -
21:01
Autorestomod and Manic Mechanic
1 year agoFord Column Shifter Broken
14 -
12:05
Real Fast Nowhere
1 year ago2001 Sportster Shift Shaft Replacement
15 -
5:34
Garage Boys
4 years agoHow To Fix Ford Gear Shifter
16 -
4:57
Humble Mechanic
6 years agoComplete Guide To Fixing a Sloppy or Worn Shifter
13 -
11:55
NightWrencher
1 year ago $0.01 earnedHow To Install A Clutch | Centerforce 2 Installation For A Carbureted Turbo LS |
62 -
4:52
BENZTRAINZ
3 years ago $0.07 earnedMARX 21 MOTOR / MARX 1095 SHELL / MOTOR INSTALLED / FIRST TEST
3032