Harvest Right Vacuum Error #9 Part 7 Epoxying the connector

We have started getting vacuum error #9 during the freeze and dry cycles.

In this series, we will be going over the steps we are taking to solve this problem.

I have seen lots of posts about this same error, and some still don't have any solution for the problem.
👉 The Freeze Dryer we have was manufactured in April 2022.
👉 We have only had it for a few months
👉 Currently we have completed 58 batches

We start out with the basic checklist and then work into the other possibilities.

Follow the series to see how it turns out.

✅ Part 1 - basic troubleshooting - https://youtu.be/pL_B77mMNqY
✅ Part 2 - checking for epoxy leak and off-gassing. - https://youtu.be/TTfgsNdSCeY
✅ Part 3 - Testing the vacuum leak - https://youtu.be/ecSMyqsmbU4
✅ Part 4 - Sensor leak finally fixed but still not working https://youtu.be/jeRfDPp9dRQ
✅ Part 5 - Fixing still another leak - https://youtu.be/TnxwgKsYhJI
✅ Part 6 - Putting epoxy on the wires - https://youtu.be/HeJpmn-mdgE
✅ Part 7 - Epoxy the connector - https://youtu.be/4tzT1Zx5Agk