How to 3D Print Nothing in Cura - Useful Slicer tip

Ultimaker Cura is the most used 3D printing slicer, and has a set of tools that most people don't even know about. The Per-Model print settings enable you to change part of your print to be different than other parts, even going as far as enabling you to turn off parts of a 3D print.

Join the mailing list and never miss anything important: https://bit.ly/3DPPnews

Be sure to like, subscribe, share and enjoy.

3D Printing Professor is made possible by YOU!
https://www.3dpprofessor.com/support/

I'm social!
https://discord.gg/rpwXqE5
https://twitter.com/3DPProfessor
https://www.facebook.com/3DProfessor/

Buy the Beginner's Guide to the 3D Printing Galaxy on Amazon: https://amzn.to/2ws7OiT

Shop on Amazon to support the channel: https://bit.ly/3DPPrinters

Follow my other 3D printing adventures at: https://www.3dpprofessor.com

All music by Kevin MacLeod (incompetech.com)
Licensed under Creative Commons: By Attribution 3.0 License
https://creativecommons.org/licenses/by/3.0/

0:00 Why would you want to print nothing?
3:25 How to use the Per-Model settings in Cura
7:41 Check out PrintABlok:SkyForce