Is the Shark V2 3-in-1 any good? 3D Printer and laser engraver... mess

The Shark V2, a combination 3D printer and engraver. But from the start it was riddled with questionable engineering, ominous warnings, and zero wire management. But despite all this does it work? Let's find out.

Be sure to like, subscribe, share and enjoy.

3D Printing Professor is made possible by YOU!
https://www.3dpprofessor.com/support/

I'm social!
https://discord.gg/rpwXqE5
https://twitter.com/3DPProfessor
https://www.facebook.com/3DProfessor/

Buy the Beginner's Guide to the 3D Printing Galaxy on Amazon: https://amzn.to/2ws7OiT

Shop on Amazon to support the channel: https://bit.ly/3DPPrinters

Follow my other 3D printing adventures at: https://www.3dpprofessor.com
Join the mailing list and never miss anything important: https://bit.ly/3DPPnews

All music by Kevin MacLeod (incompetech.com)
Licensed under Creative Commons: By Attribution 3.0 License
https://creativecommons.org/licenses/by/3.0/

1:04 Problems even before it's turned on
2:40 Shipping workarounds? On the V2?
3:28 First print
5:44 Let's Laser!
8:11 Can it cut?
11:05 It's not all bad
12:49 Better than the rest
13:29 Can you laser on a 3D print?
14:26 #Whatchamakin