CRV 1-2-3, Episode Four: Remove Snap Ring, Bearing, Ball Joint & ABS Sensor from Steering Knuckle

CRV 1-2-3 documents - in ten minute videos - the trials I went through in turning a salvage title CRV EX AWD into something drivable. This vehicle came from New England. There were dead cockroaches throughout, it smelled like someone had died in it, and the rust. OMG, the rust. They use so much salt up there I was shocked that any of the car's frame remained. In episode one I show you how to start taking apart the front suspension. ALL OF IT HAD TO BE REPLACED!!!!

In this episode: how to remove all the parts pressed or bolted into your Gen 2 Honda CRV steering knuckle, and how to repaint it to look almost like new (plus dust shield). Car repair

Typical snap ring pliers: https://www.amazon.com/Powerbuilt-Internal-External-Straight-Remover/dp/B07M87HNXH/ref=sr_1_1?crid=O7ICC45ZRO96&keywords=Powerbuilt+Combo+Switch+Internal%2FExternal+Snap+Ring+Pliers%2C+Straight%2FBent+Jaw+for+Ring&qid=1658827050&s=hi&sprefix=powerbuilt+combo+switch+internal%2Fexternal+snap+ring+pliers%2C+straight%2Fbent+jaw+for+ring%2Ctools%2C61&sr=1-1

My ball joint press kit: https://www.amazon.com/gp/product/B01N7CO50E/ref=ppx_yo_dt_b_search_asin_title?ie=UTF8&psc=1

Check out my books at: https://www.amazon.com/T-C-McCarthy/e/B004A2JC3U?ref=sr_ntt_srch_lnk_1&qid=1656758836&sr=8-1

Follow me on twitter: https://twitter.com/TipsWhip

Follow me on Instagram: https://www.instagram.com/whiptipsyt/