NEW N64RGB Version 3 Installation

The latest version of the N64RGB (hardware V3, firmware V3).Like its predecessors, this mod board enables RGB output from all Nintendo 64 consoles.

Use this guide as your primary installation guide first: https://etim.net.au/n64rgb/instructions-new/

This time however, V3 also supports component video output. In addition, the deblur option can now be switched on and off via a controller button combination rather than a physical switch installed (although this option can also be still used). Another function of V3 is the ability to reset the console via a button combination on the controller.

This video may be useful to beginners or troubleshooters installing the mod board as I demonstrate the installation techniques I use to install the N64RGB board.

email: [email protected]
https://www.facebook.com/RGB.Rob

N64RGB kits available from here: https://etim.net.au/shop/shop.php?crn=209

time stamps
0:00 Intro
0:45 N64RGB V2 versus V3 comparison
2:09 Prepping the video encoder/DAC
3:58 Prepping the N64RGB Board
5:56 Prepping the wires
8:51 Soldering wires to DAC
11:46 Soldering wires to N64RGB Board
14:19 Soldering wires to N64 multiout port
17:14 Reset and Deblur via controller installtion
21:10 Physical deblur switch installation
22:51 Shielding plate modification
25:12 Final ground connection
26:20 Testing for shorts
27:22 Testing the modded console
28:00 Controller button combo reset test
29:08 Hot gluing physical deblur switch in place
30:21 Deblur switch testing