Power-Stop Install Follow-up & Wheel Mounting Surface Cleaning – 08/15/2022
The title more or less sums it up. So, 7,725 miles after I install the Power-Stop Z23 Evolution Sport Brake Kit I will get very occasional & intermittent brake pulsations. I show in the video how lateral runout on the tire/ wheel assembly can be a contributor to brake pulsation. It is just as important to make sure that the surface between the wheel and rotor is clean as it is between the rotor and hub-bearing flange; because build-up of anything on the wheel mounting surface can cause the wheel to clamp down unevenly on the rotor & could make it run unevenly. I clean the powder coating and residual buildup off the wheel and off the mounting surface of the brake rotor, along with turning the wheel 144 degrees to get rid of the intermittent brake pulsation.
To see this video on my You Tube channel:
-
4:48
Pitposse
5 months agoHow to Remove a Harley Davidson Wheel Bearing using Pit Posse Remover & Installer VT102
3 -
2:52
USAfluid.Com Video Archive
1 year agoToyota Corolla Complete Wheel Treatment & Preservation With USA Fluid
82 -
36:20
Suburbanator91
2 years agoReplacing the Wheel Speed Sensor On My 2018 Ram 3500 (SRW) – 09/22/2021
60 -
4:59
SCRAPYARD CUSTOM PAINT
2 months agoFinished!! Rear tire assembly part 1
481 -
19:07
RodsShop Automotive How To Tutorials
3 years ago $0.01 earnedHow To Replace Wheel Bearing Hub and Rotor 92 99 Suburban 2500 4WD
142 -
16:58
Endless Money Pits
3 years ago $0.02 earnedBMW Brake Caliper Rebuild & Bleed 1998-2006
762 -
2:23
Pitposse
5 months agoHow to Remove a Wheel Bearing Using Pit Posse PP1692 Wheel Bearing Remover (Street)
9 -
36:19
i.e.427 Garage
1 year ago $0.09 earnedBattery Box, E-brake Handle and........... More Panels
44 -
15:14
RevMatch
2 years agoBMW 330i Solid Engine Mounts Install
26 -
0:36
RajbirMangat
1 year agoPower Stop Autospecialty Kit Features