Cutting Flange To Fit Metal Roof Sheets

Phil shows you how to make a flange seal to the roofing materials.

⏱️⏱️Chapters⏱️⏱️
00:00 Follow along with a handyman
00:25 How to seal the flange over the metal ridges
01:20 Fasten from the middle and move out to keep it spread out
03:42 Be an American, not an American't

🙏 Subscribe, 👍, it helps a lot!!
➤❓/ 💬: ask@straightarrowrepair.com
➤ Follow https://straightarrowrepair.com/pipf

➤➤I get a little for the channel-no charge for you if you use the links:
➤➤Shop Amazon https://amzn.to/3CxD1T4
➤➤Tool lists & recommended products🧰 https://straightarrowrepair.com/0lvf

➤➤Services We use
➤➤MORNINGFA·ME https://morningfa.me/invite/StraightArrowRepair
➤➤A2 Hosting http://www.a2hosting.com/refer/140244
➤➤Tubebuddy https://www.tubebuddy.com/StraightArrowRepair
➤➤Apsumo http://fbuy.me/v/philbridges
➤➤VidIQ: https://vidiq.com/straightarrowrepair

#MetalRoof, #MetalRoofing, #diymetalroof

Transcript:
Hi, I'm Phil Bridges, owner of Straight Arrow Repair. Ever want to know how a repairman fixes things? Well come with me, and I'll show you how I solve problems. Let's make things better together.

We're putting the vent over a hole that was cut. If you noticed the vent is much, the flange is much bigger than the ribs. So, what I do is I get the center of where that rib is going to be might no fall exactly in the center of the vent. And then I cut so that there's a v, and then I can fasten these down. And these on the outside edge when it's close like that I'll let it get mashed down and fold it over.

But I'm going to do it on the top. Also. All right, and then when you fasten, you want to make sure you start in the middle, work your way out. That way. Everything's so I'm spreading myself out. I'm going to go to the top.

You see how that vent, that v that I cut in that vent flange that's around that metal to wrap down around. That way I can seal it all up, and it will have a good tight fit before you can get to sealing it. I don't recommend using a screw gun for a hammer.

This is Phil Bridges, if you like what you saw and think it might be helpful to somebody else, push that like button and let other people know what you and I know, and we'll work together toward making a brighter future. By the way, we're not Amera-Can'ts, we're Americans. See you next time.

commercial metal roofing installation,cutting flange to fit metal roof sheets,diy metal roof,how to install a metal roof,installing a metal roof,metal panel installation,metal roof,metal roof installation,metal roof penetration,metal roof penetration installation,metal roof pipe boot,metal roofing 101,metal roofing flashing,metal roofing installation,metal roofing tips and tricks,roof tar for leaks,roof tar sealant,Straight Arrow Repair,vent pipe flashing