Nitro RC Engine and Exhaust pipe Powdercoat disassembly and reassembly tear down powder coat coating
4 years ago
21
I wanted to protect my unfinished aluminum on my nitro RC engine. I'm not worried about the anodized stuff. Anodized aluminum is corrosion resistant. I had to completely tear the block down to powder coat the block. Engine looks pretty good. Powder coat is the only way to go. Below is the powder coating machine I used.
Loading comments...
-
23:06
Exploring With Nug
1 day ago $0.04 earned30 Years Later: The Nurse Who Vanished Without a Trace
41.6K2 -
18:23
DepressedGinger
1 day ago $0.13 earnedDems have *HUGE* fight over who should run, start turning on each other
52.4K33 -
24:00
CarlCrusher
2 days agoReports of Disappearing Ghost Orbs and Shapeshifting Skinwalkers
40K6 -
13:03
JoBlo Originals
1 day agoSucker Punch - NOT As Bad As You Thought?
39.1K17 -
10:38
Tactical Advisor
1 day agoModern Lever Actions Overview
39K8 -
29:11
MYLUNCHBREAK CHANNEL PAGE
21 hours agoExposing Chicago's Tunnel System?
31.3K65 -
3:44:34
UFC - Ultimate Fighting Championship
3 days agoUFC 303: Pereira vs Prochazka 2 | June 29
36.7K10 -
35:01
Candace Owens
17 hours agoThe Conversation Every Married Couple Has
77.1K100 -
35:00
My Self Reliance
18 hours agoHand-Built Stone Chicken Coop: Ultimate DIY Project for My Permaculture Homestead
60.5K86 -
1:43:48
Bright Insight
21 hours agoWhat You Must Know about Graham Hancock/Flint Dibble Debate (w/ @DeDunking)
82.9K79