G2 Extruder Stepper Motor Replacement
3 years ago
2
It seems that the failed extruder cooling fan caused the extruder stepper motor to fail.
After the failed extruder cooling fan caused the hot end to overheat, the stepper motor started acting up. If would make a loud buzzing sound at slower speeds and ultimately stopped turning at all. SO it was time to replace that part.
I found that setting 3.0mm of exposed shaft beyond the end of the extruder drive wheel worked well.
New stepper motor from:
https://solidstateprinters.com/
Subscribe for more content like this
Comment, rate, share & click the bell icon
And as always, thanks for watching
Intro/Outro:
Louisiana Fairytale by Austin Rogers
https://web.archive.org/web/20170402222425/http://drfiddle.com/show_tune.php?id=94
Loading comments...
-
4:21
CampWedge
1 year ago $0.51 earnedKitchen slide motor replacement
125 -
25:05
fintech
1 year agoOrca Extruder System Nema 14 Ultra Light weight with BLtouch Part 2
1 -
4:43
fintech
4 years ago3D printer stepper motor hard to turn, binding, stiff, rubbing, making noise, bad bearing stuck
2 -
9:29
FullThrottlePerformanceSpeedShop
1 year agoReplacing a Blower motor on a 2001 Ford Ranger
4 -
2:29
Primal Woods
2 years ago2022 Jun 24 Wood-Mizer Up-Down Motor Replacement
14 -
4:28
fintech
3 years ago $0.01 earnedHot Stepper Motor fix marlin 2.0 Trinamic TMC2209 TMC2208 Extruder How to set current repair
13 -
6:21
elite194 model trains
3 years agoAthearn SD45 GP35 rebuild part 6 solder motor clips
4 -
7:39
fintech
2 years agoOrca Extruder System Nema 14 Ultra Light weight with BLtouch Part 1
1 -
5:31
brakthehun
2 years agoCO2 wiring 15 - Stepper Motors
3 -
10:04
elite194 model trains
3 years agoAthearn SD45 GP35 rebuild part 7 putting the motor back together
3