ProShaper Boat Build: Removing the floor and engine

https://www.proshaper.com
Our Amazon Storefront:
https://www.amazon.com/shop/proshaper

We finished cutting out the floor of the wellcraft as there was rot everywhere. Wray and Frank worked on the engine to see if it will start and run. We did end up getting it to run and at higher rpm's sounded a lot better however there is a cylinder that needs some attention. We then removed the motor, cleaned up the boat and are ready for phase 2!

Email: Wray@Proshaper.com
Website: https://www.proshaper.com
Facebook: https://www.facebook.com/ProShaper/
Instagram: https://www.instagram.com/proshaper/
Twitter: https://twitter.com/ProshaperM
Linkedin: https://www.linkedin.com/company/pros...