3d printed Mac 11, The Middleton Made "Mac N Cheese"

By far my favorite 3d printed project yet.
The Mac N Cheese consists of 3 parts that dove tail and bolt together.
If you melt the front of break the recoil area you can simple print the part and not scrap the entire lower.
The 2 failures to feed on the first round where my fault, I loaded 34 rounds into a 33 round mag, this caused the round to tip straight up.
I also needed to tighten the lower bolts on the optic mount clamp first.

Want to support the channel?
Buy some reloading case lube!
https://www.amazon.com/s?i=merchant-items&me=AJPCPNTLWYLLN
https://www.ebay.com/str/hilineprecision