Stratix 5700 CLI Commands Using HyperTerminal For Boot Recovery | Stratix 5700 Will Not Boot

So your Stratix 5700 switch will not boot up, I understand & have been there so I made this video to show how to recover from that along with helpful tricks from Rockwell Tech notes.

HyperTerminal was widely used in Windows XP & Windows 7 which now, a lot of people have started using PuTTY.

But there are limiting factors using PuTTY so I still use HyperTerminal on all of my Windows 10 machines.

Video Contents:
0:00 Talking about using HyperTerminal
2:35 Talking about the USB to Serial Adaptor & Setup
3:20 Setting The Baud rate of the USB to Serial Connection
5:10 TechNote about NOT BOOTING COMPLETELY
5:45 Using the CLI command in HyperTerminal
6:30 Note - If NO Boot Then You Will Not be Asked a password
7:10 Checking the Current Boot - Turn Off Manual Boot
9:41 Creating a Bootable SD card
13:45 Singing Into the Stratix 5700 Using Webpage
15:30 Syncing the IOS to the SD card for backup
16:30 Describing the recovery process the simple way
25:05 Important connection note about the video - Limit confusion
28:10 What the proper files look like on the SD card

Get the Boot Code: https://mmini.me/Join-Here

I hope you enjoyed the video.

Thank you for watching the video.

Learn, Implement, Succeed

If you are interested in getting serious about your knowledge & learning how to better your career then check out our training center.

Don't forget https://mmini.me/Join-Here

#HyperTerminal #Stratix5700