Hand sanding and polishing knife handles

After using a router to establish the basic handle geometry, I use a 2x42 inch belt grinder to sand off the raised areas left by the router, then I move to the 1x42 belt grinder and do some very careful shaping. Then I hand sand. The handle usually can be hand sanded in about two and a half hours. When the hand sanding is finished, it goes the buffer and a nice sheen is buffed into the woods surface.

As an affiliate for the links below, I get a small fee or commission if you make a purchase.
My website https://bcblades.net/
Amazon https://amzn.to/3DqKTaP
Combat Abrasives https://bit.ly/3mFIWRL
Renegade products https://bit.ly/3ssp9Go
Maverick Abrasives https://bit.ly/3kxAyBp
Donate https://www.paypal.com/donate/?business=JAX9BNBWK49PE&no_recurring=0&currency_code=USD