3 years ago

We are installing the shower pan for the trailer that was majorly water damaged from toilet high pressure overflow busting.

⏱️⏱️Chapters⏱️⏱️
00:00 Follow along with a handyman
00:25 There's lots of instructions included with the shower pan on how to get floor level
01:00 We've located where the studs are, mobile homes can be pretty sparse with studs
02:00 We're not using the backer board because we already have paneling
03:00 Installed an Allen and Roth Shower Base
03:25 Be an American not an American't

🙏 Subscribe, 👍, it helps a lot!!
➤❓/ 💬: [email protected]
➤ Follow https://straightarrowrepair.com/pipf

➤➤I get a little for the channel-no charge for you if you use the links:
➤➤Shop Amazon https://amzn.to/3CxD1T4
➤➤Tool lists & recommended products🧰 https://straightarrowrepair.com/0lvf

➤➤Services We use
➤➤MORNINGFA·ME https://morningfa.me/invite/StraightArrowRepair
➤➤A2 Hosting http://www.a2hosting.com/refer/140244
➤➤Tubebuddy https://www.tubebuddy.com/StraightArrowRepair
➤➤Apsumo http://fbuy.me/v/philbridges
➤➤VidIQ: https://vidiq.com/straightarrowrepair

Transcript:
Hi, I'm Phil Bridges, owner of Straight Arrow Repair. Ever want to know how a repairman fixes things? Well come with me, and I'll show you how I solve problems. Let's make things better together.

Now, this gives quite a lot of instructions on how to get your floor level. In this case, we already had that done. How to get is so that it's the floor is level so that when this sits, it has a slope that goes that way. And into the drain. It's also recommended that you not use putty tape, but silicone here and then we've located where the studs are.

In this case, mobile homes are pretty sparse and a pretty small. So you have to be pretty careful what I've done is look around for the staples, happen to be a stud here, stud here, and then I could see a staple and see a staple right there. So we drill holes where that, those studs are and then we'll put screws in it.

That's how flimsy the walls are this is supposed to have backer-board over it, but we're not going to do that because we already have paneling to fasten to and in that case, again, it has instructions on how to install the backer board and then the, the plastic over it. We're going to use.

If you were doing a ceramic tile, would do the hardy backer and then your do your would do your ceramic tile and it would run, you're hardy backer, would go over the top of this lip and the water would run and then the ceramic tile would go on that and it all run inside there is how we do the base, the floor. You'll have to follow the instructions before you put the drain in.

We've already done all that to make sure the floor was level supported properly. If there's screws. And this thing is not moving and it will be walking that is for the Allen and Roth base. There you go, guys.

This is Phil Bridges, if you like what you saw and think it might be helpful to somebody else, push that like button and let other people know what you and I know, and we'll work together toward making a brighter future. By the way, we're not Amera-Can'ts we're Americans. See you next time.

#MobileHomeRepair, #MobileHomeImprovement, #ShowerBaseInstall

Loading comments...